Placing a separate magnet there will create a stable electromagnetic connection with the solenoid and trick the machine into thinking that the lid is.
Whirlpool washing machine door locked shut.
On most whirlpool models the door must be closed and locked before any wash cycle will begin.
Your whirlpool duet washing machine automatically locks the door as a precaution against opening the door during a wash cycle.
Once the washer door is closed the washer can begin operating.
This unlocks the door and allows you to access the washer.
Step 2 hold down the control lock button on your whirlpool washer for three seconds at the end of the washing cycle.
Whirlpool washer door or lid won t lock.
If the door lock is defective the washer door will not latch properly.
Set a magnet on the site where the lid lock switch meets the washer cabinet.
The door lock secures the washer door shut during operation.
These switches are generally located on the washer s door frame.
If the appliance determines a problem with the system or a mechanical failure occurs the door will not unlock automatically.
If the water in the washer is warmer than 122 degrees fahrenheit or the water level is set higher than wool delicate or hand wash the washer must drain before the door latch will unlock.
If the door did not lock small hands or preoccupied minds might open.
The front load washer features a door switch that is actually a safety feature.
At the conclusion of the cycle the control will activate the door unlock solenoid or will deactivate the.
Just under the unit s housing at this spot there is a solenoid which is a type of powerful electromagnet.
My washer was stuck in the locked position and this is how i fixed it.
Door lock motor and switch assembly.
You can manually unlock the door.
Once you re finished with the washing machine be sure to put the screw back into place.
Go ahead and inspect the door striker to ensure it s engaging properly with the lock assembly.
Pull on dangling plastic cord or strap on the top right of the access compartment.
When the cycle is started the washer control will activate the lock solenoid wax motor to prevent the door or lid from being opened.
My washer was stuck in the locked position and this is how i fixed it.
