One of the more difficult problems for do it yourselfers to diagnose is a worn cable pulley on an extension spring door.
Why does my garage door track to one side.
Move the bottom of the track on the right closer to the door so it can t shift back.
Or it could just be that the hardware has become loose over time.
Thanks for the quick response.
Maybe someone bumped into it recently.
Click on a problem below to see the possible causes and solutions.
It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw.
The vertical tracks should be in a slight v instead of being plumb up down.
Bent tracks on your garage door need immediate repair to get the door working properly.
Yeah that was it.
The door runs are housed in a garage door track one on each side of the garage door.
I have no overhead garage door one third horsepower.
Misaligned tracks misaligned tracks are another common cause for a garage door going off track.
With misaligned tracks the risk of the rollers coming off the tracks gets much higher.
Garage door shifts to one side.
If you ve had your door for a while or are in and out of it a lot it can easily end up out of alignment.
Bottom of the door is up on one side.
I had a garage door company here that told me my garage door needs to be balanced and showed me how it would not stay up by itself when door is not engaged.
Push the door back to adjust the door and get the center aligned again.
This usually happens when the bolts holding the horizontal tracks get loose causing the bracket to wobble at the slightest unnatural vibrations of the door.
Your door has simply shifted to one side.
The cable is attached to the door and runs to an s hook that attaches to the track support.
The front measured 15 and the back measured 16 from the wall.
By pushing the door back into position you should have made the vertical track straighten.
There are of course many other problems that can keep your garage door from functioning properly.
Most track damage happens to the vertical tracks that attach to the wall of the garage door opening.
With the door propped open take the s hook out of the support and tighten or loosen the cable as needed.